Aspicore

Hi
I successfully installed the "GSM Tracker 3_v3.14" in my mobile Nokia N73,
Here I have some doubt, any one clear me
Please send me details of,
Mod : it’s in Cell Information
Status :
Bar :
Also I want to save log file, normally its not saving

Mode:

Mode of the cellular network. (Enum TNetworkMode)
2 = GSM/GPRS or DCS1800 network, 6 = WCDMA

Status:

Phone network status. (Enum TNetworkStatus)
0 = Status is unknown.
1 = A network that the mobile device is allowed to register to.
2 = Currently registered network.
3 = A network that the ME is not allowed to register to.

Band:

On CDMA networks, the band and band class of the CDMA network operator. (Enum TNetworkBandInfo)
0 = The current band and band class is unknown.
1 = The network operates at 800MHz on Band A.
2 = The network operates at 800MHz on Band B.
3 = The network operates at 800MHz on Band C.
4 = The network operates at 1900MHz on Band A.
5 = The network operates at 1900MHz on Band B.
6 = The network operates at 1900MHz on Band C.
7 = The network operates at 1900MHz on Band D.
8 = The network operates at 1900MHz on Band E.
9 = The network operates at 1900MHz on Band F.

Access:

On GSM/WCDMA networks, the type of network access. (Enum TNetworkAccess)
0 = This is used when there is no network activity and therefore no RAT active.
1 = The access technology is GSM.
2 = The access technology is GSM COMPACT. However GSM COMPACT systems which use GSM frequency bands but with the CBPCCH broadcast channel are considered as a separate access technology from GSM.
3 = The access technology is UTRAN (UMTS Network).

Bar:
Describes the phone's current signal strength (SSI).
The absolute number of signal "bars" that the phone should display.

About saving the log file, have a look at
F.A.Q. 29) NMEA logging
http://www.aspicore.com/support/gsmtrckr/default.htm#NMEAlogging
and "Storing Cell ID in Internal Logging File?"
http://www.aspicore-asp.com/phpbb2/viewtopic.php?t=397

Is there a setting that will include all the cell data in the log file? Currently I'm getting only cell ID, local Area (LAC), Name, MCC, and MNC. I would also like to get SSI, Mode, etc. in the log file, which I am using to map Cell towers. Barring that, is there another way (SMS perhaps) to configure what information is sent without setting up a server?

@dawsora:

SSI and Mode will be included in the log file in the forthcoming version 3.16 to be released soon.

Configuration can be changed in two ways:

1) Manually on the device through the settings menu either individually option by option or by batch by importing a settings XML file (provided that you have exported and possibly modified a settings XML file earlier into the local flash disk).

2) Remotely with Aspicore's remote management solution. For more details about this solution, contact sales@aspicore.com